Evermount EM-T1B Instructions

PLEASE READ THESE INSTRUCTIONS CAREFULLY AND KEEP FOR FUTURE REFERENCE! IF YOU
DO NOT UNDERSTAND THE INSTRUCTIONS, OR DO NOT FEEL THAT YOU CAN FOLLOW THEM
SAFELY, CONTACT A QUALIFIED CONTRACTOR.THE WARRANTY WILL BE HONOURED IF
ACCOMPANIED BY AN ORIGINAL SALES RECEIPT, AND ONLY IF THE INSTRUCTIONS HAVE BEEN
FOLLOWED EXACTLY. Before beginning, please check to ensure you have all the parts listed below. To
acquire missing parts please visit www.everik.com/parts.html or call 1-866-604-6966.
• The EverMount EM-T1B is designed to mount a Plasma or LCD monitor onto a vertical wall. Hardware for
mounting to a wood stud is included. For mounting to any other surface, contact a qualified contractor.
• This product will hold flat screens 32 to 62 inches and weighing up to 165 lbs.
• You will need a Phillips screwdriver, and a drill with a 3/16" bit.
• A second person will be required to assist with step 3 and 4.
• If you do not understand the instructions, or are not sure you can follow them safely, contact a qualified
contractor.
Bag Ref
1 A
B
C
D
2 E
F
G
3 H
I
J
4 K
L
M

Step One

If a 5 degree tilt is desired, install tilt plates, otherwise
continue to step 2.
To install tilt plates on monitor brackets:
i) Attach a tilt plate to each side of the monitor bracket
using tilt plate screws (U), washers (W) and nylon
nuts (V) as shown.
ii) Repeat this process for the other monitor bracket.
iii) The tilt plate's "hooks" are placed over the top track
of the wall plate in step 4.
062010
INSTRUCTIONS
Item
M4 Lock Washer
M4x12 bolt
M4x32 bolt
Cotter Pin
M5 Lock Washer
M5x12 bolt
M5x32 bolt
M6 Lock Washer
M6x12 bolt
M6x32 bolt
M8 Lock Washer
M8x16 bolt
M8x40 bolt

PARTS LIST

Qty Bag Ref
4 5 N
4 O
4 P
1 Q
4 6 R
4 S
4 T
4 7 U
4 V
4 W
4
4
4
W
U
Item
Large Spacer
Small Spacer
Large Washer
Small Washer
Concrete Anchor
Lag Bolt
Large Washer
Small Hex Bolt
Nut
Washer
Figure 1
V
Monitor Bracket
EM-T1B
Qty
4
4
4
4
6
6
6
8
8
16
Tilt Plate
1