Advertisement
J-Box Installation
1
Turning Off the Power
□ Turn the power OFF at the switch and fusebox or the
circuit breaker.
□ Remove the existing trim installed in the recessed
housing.
2
Disconnecting and removing
components
□ Disconnect the E26 adapter (DD) (See Fig.1).
□ Remove the mounting bracket (BB) from the fixture (AA).
(See Fig. 2).
□ Remove the 4 in. mounting clip springs (CC) from the
mounting bracket (BB) (See Fig. 3).
Fig.1
Fig. 2
Fig. 3
DD
BB
AA
CC
3
Identifying the wires
□ Identify the wiring: (black - line voltage, white - neutral
and green - ground)
□ Use the wire nuts (JJ) to connect the stripped wires with
male connector (EE) to the two wires coming from the
J-box (black - line voltage, white - neutral).
□ Determine if the ground wire is inside the J-box. If
not, then secure the ground wire (FF) provided to the
mounting bracket (BB) (See Fig. 4).
Fig. 4
JJ
FF
4
Choosing a color temperature
before installing
□ Use the slide switch to choose a color
temperature before installing. Soft White
(SW), Bright White (BW), Daylight (DL) or
choose to adjust the color temperature
from the wall switch (SWITCH) (See Fig. 5).
Fig. 5
Soft White
3000K
Bright White
4000K
Daylight
5000K
Switch*
5
Please contact 1-800-543-3348 for further assistance.
EE
BB
WWW.FEIT.COM
Advertisement
