AEG FSB42607Z User Manual page 49

Problem and alarm code
Malfunction of the water level detec‐
tion sensor.
• The lights related to MY TIME
selection bar flash 4 times inter‐
mittently.
• An acoustic signal sounds inter‐
mittently.
Malfunction of the wash pump or the
drain pump.
• The lights related to MY TIME
selection bar flash 5 times inter‐
mittently.
• An acoustic signal sounds inter‐
mittently.
The temperature of the water inside
the appliance is too high or malfunc‐
tion of the temperature sensor oc‐
curred.
• The lights related to MY TIME
selection bar flash 6 times inter‐
mittently.
• An acoustic signal sounds inter‐
mittently.
Technical malfunction of the appli‐
ance.
• The lights related to MY TIME
selection bar flash 12 times in‐
termittently.
• An acoustic signal sounds inter‐
mittently.
The level of water inside the appli‐
ance is too high.
• The lights related to MY TIME
selection bar flash 15 times in‐
termittently.
• An acoustic signal sounds inter‐
mittently.
The appliance stops and starts
more times during operation.
The programme lasts too long.
Small leak from the appliance door.
Possible cause and solution
• Make sure that the filters are clean.
• Switch the appliance off and on.
• Switch the appliance off and on.
• Make sure that the temperature of the inlet water does not exceed
60°C.
• Switch the appliance off and on.
• Switch the appliance off and on.
• Switch the appliance off and on.
• Make sure that the filters are clean.
• Make sure that the outlet hose is installed at the right height above the
floor. Refer to the installation instructions.
• It is normal. It provides optimal cleaning results and energy savings.
• If the delay start option is set, cancel the delay setting or wait for the
end of the countdown.
• Activating ExtraPower increases the programme duration.
• The appliance is not levelled. Loosen or tighten the adjustable feet (if
applicable).
• The appliance door is not centred on the tub. Adjust the rear foot (if ap‐
plicable).
ENGLISH 49