Table of Contents
Advertisement
8.4.2 Ethernet-JP2 Port Network Test Connect
The network cable to the JP2 port after powering on the network.
Execute the
ifconfig eth1 up
Execute
udhcpc -q -i eth1
Execute the command
8.5 TF Card Test
1) Test Preparation: One TF card
2) Insert the TF card into the card slot (see hardware schematic)
3) Run
fdisk -l
to view partitions
Execute
df -h
to view the mount
Room 02-04, 10/F, Block A, Building 8, Shenzhen International Innovation Valley, Dashi Road, Nanshan District, Shenzhen, Guangdong, China
Emai:
support@geniatech.com
command to turn on the node, then enter
to get the IP address.
ping 110.242.68.66
to test the network connection.
Tel: (+ 86) 755 86028588
ifconfig
to see if the eth1 node is turned on
11
Advertisement
Table of Contents
