Table of Contents
Advertisement
STARTING PROCEDURE
Manual Starting
1. Insert the
in the ignition and
turn to ON position.
2.
Test the throttle control lever.
3. Activate the primer (2 to 3 times).
O
NOTE: Primer is not necessary
when the
is warm.
4. Ensure the tether cut-out cap is in
position and that the cord is attach-
ed to your clothing. Check that the
r-.rvo.
r-.rr'fr-. .. , ro, ,
cut-out switch is in the
center
position.
5. Grasp manual starter handle firmly
and purl slowly until a resistance is
felt then pull vigorously. Slowly re-
lease the rewind starter handle.
..... WARNING: Do not apply throttle
.... while starting.
6. Check operation of the emergency
cut-out
switch,
and
the
tether
switch. Restart the engine .
..... WARNING: If engine does not
.... shut-off when applying the emer-
gency cut-out switch and/or by pulling
the tether cut-out cap, stop the engine
by turning off the ignition key. Do not
operate the vehicle further, see your
dealer.
7. Allow the engine to warm before
operating at full throttle.
16
Emergency Starting
Should the rewind starter rope fray and
break, the
can be started with
an emergency starter rope.
..... WARNING: Do not
start the vehi-
.... cle by the drive pulley unless it is
a true emergency situation, have the
vehicle repaired as soon as possible.
Remove the pulley guard from the
vehicle and wind the emergency rope
tight around the drive pulley between
the sliding half and the roller guard.
Start the
as per usual manual
starting.
..... WARNING: When starting the
.... vehicle in an emergency situation
by the drive pulley, do not make a knot
at the end of the emergency rope and
do not reinstall the pulley guard.
Advertisement
Table of Contents
