Table of Contents
Advertisement
en Installation instructions
Installing the appliance
Remove the grease filters.
1.
To avoid causing damage, do not bend the grease
filters.
Attach the appliance.
2.
Screw the knurled nuts onto the safety screw by
3.
hand and tighten them hand-tight.
Insert the glass support in the opening and fold it
4.
down as far as it will go.
Align the glass panel at an angle of 90° to the ap-
5.
pliance.
Insert the glass panel in the opening on the appli-
6.
ance and lock it into place.
90º
20
Insert the glass support in the opening on the glass
7.
panel and lock it into place.
Remove the edge protection.
8.
9.
Insert the grease filters.
Connect the appliance to the power supply.
10.
Piping
Note: If you are using an aluminium pipe, smooth the
connection area beforehand.
We recommend piping with an exhaust air pipe dia-
meter of 150 mm.
If the diameter of the air extraction ducting is less than
150 mm, you need a separately available reduction fit-
ting.
Establishing the exhaust air connection (exhaust
pipe, 150 mm diameter)
Secure the exhaust pipe to the air pipe connector.
1.
Establish the connection to the exhaust air opening.
2.
Seal the joints.
3.
Installing the flue duct
WARNING ‒ Risk of injury!
Components inside the appliance may have sharp
edges.
Wear protective gloves.
▶
WARNING ‒ Risk of electric shock!
Sharp-edged components inside the appliance may
damage the connecting cable.
Do not kink or trap the connecting cable.
▶
To separate the flue ducts, remove the adhesive
1.
tape or the flue duct from the protective packaging.
Remove any protective foil from both flue ducts.
2.
Use the 2 screws to screw the upper flue duct to
3.
the sides of the retaining bracket.
Advertisement
Table of Contents
