Sony HB-501P Service Manual page 5

«
CONNECTION OF PERIPHERALS
%
CONTROLLER A and B connectors
Accept joystick controllers.
See page 9.
Keyboard
See page 13.
— Cartridge slot 1/2
This slot can be used to insert
a ROM cartridge or a RAM
cartridge. See page 12.
PRINTER connector (14-pin) —1
Connect an 8 bit
parallel transfer printer
of the MSX specifications.
VIDEO/AUDIO (video/audio output) —
connector (6-pin DIN connector)
Connect to a 6-pin DIN audio/video input
of a monitor TV.
RF connecter -
Connect to the TV antenna terminal
of a normal TV receiver with a
75-ohm coaxial cable.
Ground terminal -
Ac power cord -
Cursor joystick
(supplied)
and Cursor joystick holder
Make sure to turn off the computer and all the devices to be
connected.
CONNECTING A MONITOR TV
Connecting a normal TV receiver
1 Connect the TV antenna terminal to the supplied antenna selector.
2 Connect a TV receiver to the computer.
To UHF input
f
©
Antenna
selector
(supplied)
To COMPUTER
To RF
Normal TV receiver
To a wall outlet
3 Select the channel UHF 36 for the computer.
The RF output of the computer is set to the channel UHF 36 at
factory.
Note on the channel adjustment knob
If the channel UHF 36 is occupied, or if the display distorts on the
channel UHF 36, turn the knob at the rear of the computer with a small
screwdriver to change the UHF channel.
When you turn the knob clockwise, the channel changes to 35, and if
the knob is turned counterclockwise, the channel changes to 37. The
channel can be set from 35 to 37 with the knob.
Note
Set the switch of the antenna selector to the COMPUTER position
when using the computer. To watch TV, set it to the AERIAL position.
HB-501P
1-3