Charging Other Devices; Technical Specifications - Viking X-1000 Instructions For Use Manual

Alterna�ng current (AC) charging
The AC charging input is CC/CC mode, 100-240V AC input, the ba�ery charging current is 7.5A
max 210-220W. It takes approximately 6 hours to fully charge in this charging mode.
Charging from vehicle
Charging input for charging from vehicle car is 12V 10A max. This charging method is not
intended for 24V vehicle circuits.
It takes approximately 9 hours to fully charge the X-1000 generator. (Charge the generator
from the vehicle when the engine is running, otherwise damage to the vehicle ba�ery may
occur).

CHARGING OTHER DEVICES

Charge the device to 100% before first use
DC OUTPUT
Press the main power bu�on to turn on the DC outputs. Please make sure that the total DC consump�on is less than 120 W. If the sum of the consump�on for all connected
devices is more than 120 W, the device will automa�cally shut down and the ba�ery generator needs to be restarted.
AC OUTPUT
Press the AC ON/OFF bu�on when the device is turned on.
Please make sure that the total AC consump�on is less than 1000 W. If the sum of consump�on for all connected devices is greater than 1000W, the device will automa�cally
turn off and the ba�ery generator needs to be restarted.

TECHNICAL SPECIFICATIONS

Model
Capacity
Type
Service life
Inputs
Two-pin connector
AC input (IEC 60320 C7)
AC output
Output voltage
Output power
Top performance
Maximum load
Sine wave
DC outputs
JACK 5.5/2.1mm (2x)
JACK 5.5/2.5mm (2x)
USB-A QC3.0 (2x)
USB-C PD3.0
Solar charging
Max. performance of sol.
charging
Product dimensions
Package dimensions
Mass
Material
Storage temperature
Accessories
VIKING X-1000
1010Wh/25.9V/39Ah (273,000mAh/3.7)
25.9V
Li-ion NCM polymer
min. 2000 charging cycles
Solar charging: 12-70V/12A 360W
Power adapter: 100-240V 210W
230V/50Hz
1000W
2000W
2000W/1.5s
Ultra clean
12V/7A
12V/10A
5V/3A, 9V/2A, 12V/1.5A Max 36W total
5V/3A, 9V/3A, 12V/3A, 15V/3A, 20V/5A Max. 100W
12V/10A
MPPT 360W
475x406x120mm
485x455x185mm
11.5 kg
IP65 (valid only if all input and output connectors are covered, e.g. with a
-20°C−40°C
0°C−40°C
etc.
CE, RoHS, ISO