Thawing; Cleaning; Replacing The Bulb - Pelgrim KB 7170 Manual

thawing

refrigerator
Make sure that the melt-water drain remains
unblocked. You can clear a blocked drain with
a kebab stick, for example.
The refrigerator defrosts automatically from
time to time. The melt water runs away via the
drain to a receptacle where it evaporates.
freezer
Defrost the freezer when the layer of ice
reaches a thickness of 5 mm.
Remove the contents of the freezer.
Switch the thermostat off.
Defrost the freezer.
Clean and dry the freezer.
Switch the thermostat on again.
When the freezer reaches its correct
temperature, replace the freezer's contents.
You can speed up the defrosting process by
placing a bowl of hot water in the freezer.
Keep the contents of the freezer in a cool
place and wrapped in blankets or
newspapers.
attention
Never remove the ice with the aid of sharp
objects, defrost sprays, a hair-drier, a radiant
heater, or the like. This may lead to unsafe
situations and may cause irreparable damage
to the appliance.

cleaning

attention
Before cleaning the appliance, disconnect the
plug from the wall socket. Never disconnect
the plug from the wall socket by pulling on the
lead!
Clean the interior of the appliance once a
month.
Clean the interior of the appliance once a
month. For cleaning, use the suds of a neutral
cleansing agent (a general detergent or
washing-up liquid). After cleaning, rinse the
interior with clean water and rub dry. Leave
the appliance to dry for 1 or 2 hours.
You may, if you wish, clean the mantle with an
enamel cleaner.
attention
Never clean the refrigerator with the aid of a
steam cleaner. This is dangerous.
Do not use too much moisture.
Avoid any moisture getting into electrical
components.

replacing the bulb

In the event of a malfunction, you can change
the interior light bulb of the refrigerator
yourself.
Disconnect the appliance from the wall
socket.
When replacing the inside lamp, only use
lamps of the same power as that given near
the lamp-socket (e.g.: Max. 10 W).
attention
Only use bulbs of the same design, with the
following characteristics:
Voltage: 230 V
Socket: E 14
Power: 15 W maximum.