Tips For Saving Energy - Nordmende RET346C Instruction Booklet

Recommendations
• In order to increase space and improve the appearance,the « cooling section » of
this appliance is positioned inside the back wall of the refrigerator compartment.
When the appliance is running, this wall is covered with frost or water drops,according
to weather the compressor is running or not. Do not worry. This is quite normal. The
appliance should be defrosted only if an excessively thick layer forms on the wall.
• If the appliance is not used for long time (for example during the summer
holidays)Defrost and clean the refrigerator leaving the door open to prevent the
formation of midew and smell.
• To stop the appliance completely, unplug from main socket (for cleaning and when
the doors are left open)
Conformity Information
• This equipment is designed for use at an ambient temperature within the 16°C -
43°C range.
• The appliance is designed in compliance with the IEC60335-1 / IEC60335-2-24,
2004/108/EC standards.

Tips for saving energy

1- Install the appliance in a cool, well ventilated room , but not in direct sunlight and not
near heat source (radiator, cooker.. etc. ). Otherwise use an insulating plate.
2- Allow warm food and drinks to cool down outside the appliance.
3- When thawing frozen food, place it in the refrigerator compartment. The low temperature
of the frozen food will help to cool the refrigerator compartment when it is thawing. So
it reduces the energy requirements.
4- When placing, drinks and liquids they must be covered. Otherwise humidity increases
at the appliance. Therefore the working time gets longer. Also covering drinks and
liquids helps preserve the smell and taste.
5- W hen placing food and drinks, open the appliance door as briefly as possible.
6- Keep the covers closed of any different temperature compartment in the appliance
(crisper, chiller ...etc. ).
7- Door gasket must be clean and pliable. Replace gaskets if worn.
EN - 13 -