Table of Contents
Advertisement
Settings
TAB
(All-in-one detergent)
Error readout
Restore factory de-
faults
Exit
24
Alternatives
See 1Water hardness in the chapter Before washing for the
first time.
For a water supply with a hardness above 5 °dH (9 °fH /
6 °eH / 0.9 mmol/l), fill with salt.
For a water supply with a hardness below 6°dH (10°fH /
7°eH / 1.0 mmol/l), select 4:00. The water softener is deac-
tivated and no salt needs to be added.
Pre-selected at factory: 4:04
5:00 (Off)
Activate this setting when using an all-in-one detergent that
5:01 (On)
contains rinse aid.
This setting reduces the rinse aid dosage and affects how
often the dishwasher's built-in softener is regenerated.
Pre-selected at factory: 5:00
F--
Any error messages.
When contacting the service department, you may be asked
to provide the most recent error messages.
rSt
Restores all settings to the factory defaults.
Select rSt and confirm by pressing
End
To exit the dishwasher's settings menu, select End and
press
(The menu closes automatically after three seconds.)
.
.
Advertisement
Table of Contents
