Toshiba Tecra A9 User Manual page 63

In all instances you should shut down the computer and remove the
incompatible module(s).
Use a point size 0 Phillips screwdriver to remove and fasten the screws -
the use of an incorrect screwdriver can damage the screw heads.
Installing a memory module (Slot A and Slot B)
The computer contains slots for two memory modules, one positioned
immediately over the other - the procedures are the same for installing
either module.
1. Set the computer to Boot Mode and turn its power off - make sure the
Power indicator is off (refer to the
Chapter 1,
2. Remove the AC adaptor and all cables and peripherals connected to
the computer.
3. Turn the computer upside down and remove the battery pack (refer to
the
Power-Up
4. Loosen the screw securing the memory module cover in place - please
note that this screw is attached to the cover in order to prevent it from
being lost.
Use a point size 0 Phillips screwdriver.
5. Slide your fingernail or a thin object under the cover and lift it off.
User's Manual
TECRA A9, TECRA S5, Satellite Pro S200, Satellite Pro A150
Getting Started, if required).
Replacing the battery pack
Modes, if required).
Screw
Removing the memory module cover
Turning off the power
section in Chapter 6,
section in
Power and
Memory module
cover
3-19