Black Box NBC26S-R2 Manual page 13

Chapter 4: Configuration and Setup
Step 7. Hold the brick and cords in place by strapping them down using a zip tie or a
hook-and-loop tie.
Strap
Figure 4-11. Strap the brick and cord in place using a zip tie or
hook-and-loop tie (not included).
Step 8. Install the assembled divider into the cart using the following steps.
Figure 4-12. A divider with a power brick properly attached.
NOTE: For proper installation, make certain that all power bricks are installed on the
same side of every divider.
Page 13
724-746-5500 | blackbox.com
NBC20S-R2