Table of Contents
Advertisement
NOTE:
To avoid damaging the display, do not slide the palm-rest and keyboard assembly over the display assembly.
3. Press down the display hinges and align the screw holes on the display hinges with the screw holes on the palm-rest and
keyboard assembly.
4. Replace the screw (M2.5x3.5) and the two screws (M2.5x5) that secure the right display hinge to the system board.
5. Replace the three screws (M2.5x5) that secure the left display hinge to the system board.
6. Connect the display cable to the system board, close the latch, and adhere the tape that secures the display cable to the
system board.
Next steps
1. Install the
base
cover.
2. Follow the procedure in
Power-adapter port
Removing the power-adapter port
Prerequisites
1. Follow the procedure in
2. Remove the
base
cover.
About this task
The figure indicates the location of the power-adapter port and provides a visual representation of the removal procedure.
44
Removing and installing components
After working inside your
Before working inside your
computer.
computer.
Advertisement
Table of Contents
