Warranty - Haier LED46T3 Service Manual

Verify if the television is properly plugged.
No picture, Verify if the television is properly
no sound supplied power.
Verify if electricity is available.
Verify if correct signals are input.
Press INPUT button to change signal
Blank screen input to TV input.
Restart the television of power supply
is interrupted.
Press Mute button and verify if Mute
mode is set.
Switch to other channel and verify if
No sound
the same problem happens.
Press VOL+ button to see if the
problem can be solved.
Verify if sound system is correct. Refer
Poor sound
to Page 20 for adjustments.
Verify if correct channel is selected.
No picture
Adjust the antenna.
in some
Make adjustments by Fine Tune and
channel
Manual Scan.
No color Verify if the same problem exists in
for some other channels.
channel Check out of picture and sound
program systems.
(black and Refer to relative instructions in the
white) Manual for color adjust.
Verify if the antenna is correctly
Spots with connected.
some or all Verify if the antenna is in good
pictures condition.
Make fine adjustment of channel.
Horizontal/
vertical bars Check for local interference such as
or picture an electrical appliance or power tool.
shaking
Disconnect the television from power
supply and, 10 seconds later, connect
Television
the television to the power supply.
out of
If the problem still exists, contact
control
authorized after-sales service for
technical assistance.
Note
Do not leave the television with static picture in
an extended period as the image may become
permanently burned.
Universal Remote Control / Maintenance / Specification
Note
Production of the LCD screen requires high and
precision technologies. However, there might be
some dark or bright (red, blue or green) spots,
or some anomalistic stripes or spots. This is not
defect. If the TV set is used in an area 2,400 meters
above the sea level where the air pressure is below
750 hpa, the picture on the LCD screen may be
affected and a muffled sound might be produced.
These phenomena might happen in the area
1,500 meters above the sea level. This is resulted
from difference between air pressures inside and
outside the display. This is not a defect covered by
the limited warranty.

Warranty

Warranty
This Haier brand product, when shipped in its original
container, will be free from defective workmanship and
materials, and agrees that it will, at its option, either repair
the defect or replace the defective product with a new or
remanufactured equivalent at no change to the purchaser,
for parts or labor for the periods set forth below:
This warranty does not apply to the appearance of the
product or the exterior of the product, which has been
damaged or defaced, altered or modified in design
or construction. It does not apply to the additional
excluded items set forth below:
The warranty commences on the date the item was
purchased and the original purchase receipt must
be presented to the authorized service center before
warranty repairs are rendered.
The limited warranty described herein is in addition
to whatever implied warranties may be granted to
purchasers by law. ALL IMPLIED WARRANTIES INCLUDING
THE WARRANTIES OF MERCHANTABILITY AND FITNESS
FOR USE ARE LIMITED TO THE PERIOD(s) FROM THE DATE
OF PURCHASE SET FORTH BELOW. Some states do not
allow limitations on how long an implied warranty lasts,
so the above limitation may not apply to you.
Neither the sales personnel of the seller nor any other
person is authorized to make any warranties other than
those described herein, or to extend the duration of any
warranties beyond the time period described herein on
behalf of Haier.
The warranties described herein shall be the sole and
Haier LED HDTV EN-36