Detaching And Refitting The Rails; Detaching And Attaching The Oven Door - Siemens HA723 20U Series Instruction Manual

Caution!
Never use abrasive cleaning agents. You will scratch or
■
destroy the highly porous coating.
Never treat the ceramic coating with oven cleaner. If oven
■
cleaner accidentally gets onto it, remove it immediately with a
sponge and plenty of water.

Detaching and refitting the rails

The rails can be removed for cleaning. The oven must have
cooled down.
Detaching the rails
Lift up the front of the rail
1.
and unhook it (figure A).
2.
Then pull the whole rail forward
3.
and remove it (Fig. B).
4.
Clean the rails with cleaning agent and a sponge. For stubborn
deposits of dirt, use a brush.
Refitting the rails
First insert the rail into the rear socket, press it to the back
1.
slightly (figure A),
and then hook it into the front socket (figure B).
2.
The rails fit both the left and right sides. Ensure that, as shown
in figure B, levels 1 and 2 are below and levels 3, 4 and 5 are
above.

Detaching and attaching the oven door

For cleaning purposes and to remove the door panels, you can
detach the oven door.
The oven door hinges each have a locking lever. When the
locking levers are closed (figure A), the oven door is secured in
place. It cannot be detached. When the locking levers are open
in order to detach the oven door (Fig. B), the hinges are locked.
They cannot snap shut.
:
Risk of injury!
Whenever the hinges are not locked, they snap shut with great
force. Ensure that the locking levers are always fully closed or,
when detaching the oven door, fully open.
Detaching the door
Open the oven door fully.
1.
Fold up the two locking levers on the left and right (figure A).
2.
Close the oven door as far as the limit stop. With both hands,
3.
grip the door on the left and right-hand sides. Close the door
a little further and pull it out (figure B).
Attaching the door
Reattach the oven door in the reverse sequence to removal.
When attaching the oven door, ensure that both hinges are
1.
inserted straight into the opening (figure A).
The notch on the hinge must engage on both sides (figure B).
2.
Fold back both locking levers (figure C). Close the oven
3.
door.
:
Risk of injury!
If the oven door falls out accidentally or a hinge snaps shut, do
not reach into the hinge. Call the after­sales service.
15