Siemens EX8 LY Series Instruction Manual page 25

Connecting the wireless temperature sensor to the
control panel
You will need to connect the wireless temperature
sensor to the control panel before using the cooking
functions for the first time.
To connect the wireless temperature sensor to the
control panel, follow the instructions below:
Select the basic setting
1.
~ "Basic settings"
The indicator for one of the hotplates and the
indicator will light up. The control panels switch off.
Select the hotplate and its indicator will light up. A
2.
signal will sound. The
Press the symbol on the wireless temperature
»
3.
sensor within 30 seconds.
After a few seconds, the status of the connection
between the temperature sensor and the control
panel will appear on the hotplate's display.
Status
Connected correctly
‹
Not connected correctly: Transmission error.
‚
Not connected correctly: Temperature sensor fault.
ƒ
The cooking functions are made available once the
■
temperature sensor has been connected to the
control panel correctly.
If there is a fault with the temperature sensor, the
■
connection may not be established correctly for the
following reasons:
– Bluetooth communication error.
– You did not press the symbol on the temperature
sensor within 30 seconds of selecting a hotplate.
– The battery in the temperature sensor has run
out.
Reset the wireless temperature sensor and follow
the connection procedure once again.
If the temperature sensor and the control panel are
■
not connected correctly due to a transmission error,
follow the connection procedure once again.
If the display continues to show incorrect connection
, contact our technical after-sales service.
‚
Resetting the wireless temperature sensor
Touch and hold the
1.
10 seconds.
While you are doing this, the temperature sensor's
LED indicator will light up three times. When the LED
lights up for the third time, it will start to reset the
temperature sensor. At this point, you will need to lift
your finger off the symbol.
Once the LED goes out, this means that the wireless
temperature sensor has been reset.
Repeat the connection procedure from point 2.
2.
; see the section on
™‚...
indicator will flash.
õ
symbol for approximately 8-
»
Setting procedure
Attach the temperature sensor to the saucepan; see
1.
the section on ~ "Preparing and maintaining the
wireless temperature sensor"
Place a saucepan filled with sufficient liquid on the
2.
required hotplate and always put the lid on.
Press the
3.
sensor. The indicator
panel.
Select the hotplate on which you have placed the
4.
b
saucepan with the temperature sensor.
Select the right temperature setting from the table.
5.
The function has now been activated.
The temperature symbol
or oil has reached the right temperature for adding
the food. A signal will sound and the temperature
symbol will stop flashing.
Once the signal has sounded, take the lid off and
6.
add the food. Keep the lid on during cooking.
Do not cover the pan when using the "Frying
Note:
with a large amount of oil in the saucepan" function.
Switching off cooking functions
Select the hotplate and set it to
The hotplate will switch off and the residual heat
indicator will appear.
To re-activate the cooking functions, wait for
Note:
approximately 10 seconds.
Cooking assist functions
symbol on the wireless temperature
»
õ will light up in the control
will flash until the water
õ
in the control panel.
‹
en
25