Yamaha NIKEN GT 2020 Owner's Manual page 19

Right
1
3
2
1. Stop/Run/Start switch " /
2. Drive mode switch "MODE"
3. Hazard switch " "
Dimmer/Pass switch "
Set this switch to " " for the high
beam and to " " for the low beam.
To flash the high beam, press the
switch down to "PASS" while the
headlights are on low beam.
TIP
When the switch is set to low beam,
only the two outer headlights come on.
When the switch is set to high beam,
the two inner headlights also come on.
Turn signal switch "
To signal a right-hand turn, push this
switch to "
turn, push this switch to "
released, the switch returns to the cen-
ter position. To cancel the turn signal
lights, push the switch in after it has re-
turned to the center position.
Horn switch "
/ "
Press this switch to sound the horn.
Stop/Run/Start switch "
EAU85481
/ /PASS"
To crank the engine with the starter,
set this switch to "
the switch down towards "
page 5-2 for starting instructions prior
to starting the engine.
Set this switch to "
gine in case of an emergency, such as
when the vehicle overturns or when the
throttle cable is stuck.
Instrument and control functions
EAU66040
/ "
". To signal a left-hand
". When
EAU66030
"
EAU66061
/ / "
", and then push
". See
" to stop the en-
3-4
Hazard switch " "
With the key in the "ON" or "
tion, use this switch to turn on the haz-
ard lights (simultaneous flashing of all
turn signal lights).
The hazard lights are used in case of an
emergency or to warn other drivers
when your vehicle is stopped where it
might be a traffic hazard.
NOTICE
Do not use the hazard lights for an
extended length of time with the en-
gine not running, otherwise the bat-
tery may discharge.
Cruise control switches
See page 3-8 for an explanation of the
cruise control system.
"MENU" switch
This switch is used to make setting
changes within the multi-function me-
ter unit. (See page 3-11.)
EAU66010
" posi-
3
ECA10062
EAU84250
EAU84521