Troubleshooting - Schwinn IC2i Assembly Manual / Owner's Manual

Condition/Problem
Console will not power up/turn
on/start
Speed displayed is not
accurate
Speed displayed is always
"0"/stuck in Pause mode
No speed/RPM reading
Console shuts off (enters
sleep mode) while in use
Unit rocks/does not sit level
Pedals loose
Clicking sound when pedaling Check pedal to crank connec-
Rattling or grinding sound
when pedaling/unit difficult to
pedal
Seat post movement
Things to Check
Batteries
Display set to wrong unit of
measure. (English/Metric)
Data cable
Check data cable integrity
Check data cable
connections
Check magnet position
(requires chain guard door
removal)
Check RPM Sensor (requires
chain guard door removal)
Check data cable integrity
Check data cable
connections/orientation
Check magnet position
(requires chain guard door
removal)
Check RPM Sensor
Check leveler adjustment
Check surface under unit
Check pedal to crank connec-
tion
Check crank to axle connec-
tion
tion
Check chain tension (requires
chain guard door removal)
Check locking pin
Check adjustment knob

TROUBLESHOOTING

Solution
Make sure batteries are installed correctly. If batteries
are correctly installed, replace with a set of new
batteries.
Change display units.
Make sure the data cable is connected to the back of
the Console and the main frame assembly.
All wires in cable should be intact. If any are cut or
crimped, replace cable.
Be sure cable is connected securely.
Magnet should be in place on sprocket drive.
RPM sensor should be aligned with magnet and con-
nected to data cable. Realign sensor if necessary.
Replace if there is any damage to the sensor or the
connecting wire.
All wires in the cable should be intact. If any are cut or
crimped, replace cable.
Be sure cable is connected securely and oriented
properly.
Magnet should be in place on sprocket drive.
Contact your local distributor for further assistance.
Leveling feet may be turned in or out to level bike.
Adjustment may not be able to compensate for ex-
tremely uneven surfaces. Move bike to level area.
Pedal should be tightened securely to crank. Be sure
connection is not cross-threaded.
Crank should be tightened securely to axle.
Remove pedals. Make sure there is no debris on
threads, and reinstall the pedals
Open chain guard door to see the chain. Tension
should not be too loose (nor too tight). Contact your
local distributor for assistance.
Be sure adjustment pin is locked into one of the seat
post adjustment holes.
Be sure knob is securely tightened.
23