Advertisement
Quick Links
TXG517
07
08
07
02
06
Core Products are proud to be a member of ACID (Anti Copying in Design).
Our designs are supported through their intellectual property databank.
All copyright, design rights & intellectual property rights existing in this product,
instructions and related documents are and will remain the property of Core Products.
We will treat any infringement of these rights seriously.
Copyright © Core Products 11/2021
01
03
04
04
04
04
04
04
04
04
05
06
13
12
11
10
09
4x
Advertisement
Related Manuals for ACID Core Products TXG517
Summary of Contents for ACID Core Products TXG517
- Page 1 TXG517 Core Products are proud to be a member of ACID (Anti Copying in Design). Our designs are supported through their intellectual property databank. All copyright, design rights & intellectual property rights existing in this product, instructions and related documents are and will remain the property of Core Products.
-
Page 3: Parts List
TXG517 75min P3 Thank you for choosing this furniture. BEFORE YOU START ASSEMBLY please store the carton at room temperature for 48 hours or more so the contents can acclimatise. PLEASE RETAIN ALL PACKING UNTIL YOU HAVE COMPLETED ASSEMBLY. Information about your Pine furniture. Our pine furniture ranges have been carefully crafted from solid wood and wood fibre based composite boards. - Page 4 25mm Ø8 25mm Ø8 25mm Ø8...
- Page 5 Ensure the drawer runner side with 2 holes for dowels part 04 is facing towards the top of the panel. TOP OF PANEL TOP OF PANEL 28mm Ø4,5 GOLD Build your furniture on a soft clean cover to stop the components getting marked during assembly.
- Page 6 BACK 40mm Ø4,0 GOLD Ensure the drawer runner side with 2 holes for dowels part 04 is facing towards the top of the panel. B B B 28mm TOP OF PANEL Ø4,5 GOLD 8 x 8...
- Page 7 10mm 35mm Ø4,5 GOLD 25mm Ø8...
- Page 8 28mm Ø4,5 30mm Ø3,5 GOLD GOLD BLACK Fixing drawer safety stops 1; Insert drawers into frame by approximately 50mm. 2; Push wooden dowels in through the pre-drilled holes close to the back of the drawer sides until they are level with the inside edge of the drawer sides.
- Page 9 WARNING: CHECK FOR HIDDEN PIPES AND CABLES BEFORE DRILLING. IMPORTANT: IF YOUR WALLS ARE NOT SOLID LIKE BRICK OR STONE, YOU WILL REQUIRE SPECIALIST FITTINGS (NOT SUPPLIED). - Place fixing strip against the wall and mark position for drilling hole. - Drill hole in your wall to a depth of 30mm using a 6mm drill bit.
Need help?
Do you have a question about the Core Products TXG517 and is the answer not in the manual?
Questions and answers