Advertisement
User instructions
CANCELLING THE CURRENT PROGRAM
To cancel the currently selected program open the door and hold
down the PROGRAM SELECTION (C) (marked "end").
Close the door.
After approximately 1 minute the dishwasher will advance to the end
of cycle.
CHANGING THE PROGRAM
To change the program in progress, simply open the door and select a
new program. When the door is closed the dishwasher will automatically
select the new program.
TO SAVE ON ENERGY! ... AND PROTECT THE ENVIRONMENT
Always use the dishwasher with a full load.
Load the dishwasher as indicated in the instructions manual. If the
dishwasher is loaded incorrectly, it may lead to poor results as well
as waste water, energy and detergent.
Do not wash dishes under running water before placing them in the
dishwasher. It would just waste water and energy.
Use the washing program that is most appropriate for each type of
load.
If available, connect the dishwasher to a hot water supply up to 60°C.
If the manufacturer's instructions and recommendations are followed,
washing the same number of similarly soiled dishes in a dishwasher
consumes less water and energy than if they were washed by hand.
TO CUT DOWN ON DETERGENT CONSUMPTION! ... AND PROTECT
THE ENVIRONMENT
The phosphates contained in dishwasher detergents are harmful to the
environment. To avoid using excessive amounts of detergent and to save
on electricity, observe the following:
separate the more delicate items from dishes that are more
resistant to aggressive detergents and high temperatures;
do not pour detergent directly onto the dishes.
If the door has to be opened while washing is in progress, the program will
be interrupted. The relative light will keep flashing and a beeper will signal
that the cycle has not been completed. You must wait about 1 minute
before closing the door to restart the program. When the door is closed
the program will continue from where it was interrupted. This operation
should only be carried out if strictly necessary, because it might cause
problems in execution of the program.
30
Advertisement
