Table of Contents
Advertisement
PROBLEM
Solvent popping
Undercure or softness of
the paint film
Softness on the edge of
repair
Difficulty in polishing out
dirt nibs
SB-81-016-R1 (11/2023)
MAINTENANCE
LAMP REPLACEMENT
NOTE
Only use original Trisk Devilbiss lamps with the correct
power rating.
1. Disconnect power supply.
2. Remove the mesh.
3. Remove the old lamp.
4. Install new lamp in reverse order.
!
CAUTION
Do not touch the new lamp with your fingers. Remove the
protective paper on the lamp after you have installed it.
TROUBLESHOOTING
POSSIBLE CAUSE
Unit too close to panel
Insufficient flash off time
Paint system has fast thinner
Unit too far away
Insufficient bake time
Excessive film weight
Repair too large for I.R. unit
Too long on bake cycle
Unit too close to panel
POSSIBLE SOLUTION
Move unit further away
Increase flash off time
Use a standard or slow thinner
Move unit closer
Increase full bake time
Apply lighter coats
Split area into two, move unit for 2nd application.
If flash off is used, it will not be necessary on 2nd application.
Reduce cure time
Move unit further away
7 / 12
EN
www.carlisleft.com
Advertisement
Table of Contents
