Quoizel WKF9011EK Assembly Instruction Sheet

6 CORPORATE PARKWAY
, .
GOOSE CREEK SC 29445
. .
www quoizel com
Please go to www.quoizel.com
Tools Required: Flathead screwdriver, Phillips screwdriver, pliers, wire cutters, wire strippers, electrical tape, safety glasses.
Light Source: (3) B10 Candelabra Base bulbs 60W Maximum or
(3) Candelabra Base T8 Vintage bulbs are recommended but not supplied.
Estimated Assembly Time:
Preparation: Identify and inspect all parts before beginning installation. Check package content list and diagrams below to ensure all parts are
present. If any parts are missing or damaged, do not attempt to assemble, install, or operate the fixture. Contact customer service for replacement
parts.
Warnings and Cautions
Turn off electricity at circuit breaker or main fuse box before installation. Consult a licensed electrician if in doubt.
These instructions are provided for your safety. It is very important you read them completely before installing the fixture. We strongly
recommend that a licensed, professional electrician perform the installation.
Disconnect fixture from power source before replacing bulbs. Make sure bulbs are given sufficient time to cool before removal.
Package Contents
Mounting Screw
A
x 3
Fixture Hood
x 1
B
-
STEP 1 Install Glass Panels,
Bulbs and Fixture Hood
A. Unscrew screws from the top
edge of the Fixture Body (D) to
remove glass holder.
B. Insert Glass Panels (C) into the
slot in the bottom edge of the
Fixture Body (D). Attach the glass
holder onto the top edge of Glass
Panels (C) and align holes on it to
mounting holes on the Fixture
Body (D). Secure the glass holder
with removed screws. Tighten
gently until snug with
screwdrivers.
C. Insert bulbs onto sockets and
screw snugly into place.
D. Remove lock screws from the
T8 Vintage Bulb
(recommended
but not supplied)
Figure 1
Need assistance with parts or assembly? Call Quoizel customer service at 1-800-645-3184
2017 QuoizelInc.
Assembly Instruction Sheet #IS-WKF9011EK
for product cleaning tips. Go to the
20-30 minutes
Glass Panel
C
x 4
Fixture Body
D
x 1
Socket
Slot
Thank you for purchasing a Quoizel product.
or visit us on-line at www.quoizel.com
For Style WKF9011EK
Care + Maintenance selection.
(Step 1 Continued)
bottom edge of the Fixture Hood (B).
E. Align the label "A" on the top edge of the Fixture Body (D) to the
label "A" in the bottom edge of the Fixture Hood (B). Attach the
Fixture Hood (B) to the top edge of the Fixture Body (D) and secure
with removed lock screws. Hand tighten until snug with
screwdrivers.
STEP 2 - Mark the Location for the 3 Mounting Holes
A. Place the light fixture onto the post and mark the location of the 3
mounting holes on the fixture fitter onto the post with the marking
pen.
B
Fixture
Label "A"
Fitter
Screw
Post
Glass
Holder
C
Label "A"
-
STEP 3 M arking the
E ach M ounting
Lock
Screw
A. Remove the light fixture. Using
the center punch and hammer
marking the center of each
mounting hole location that is
D
marked with the marking pen.
1of2
Post
Lighting
Marking Pen
Mounting
Hole
Figure 2
C enter of
H ole
Hammer
Marking
Center Punch
Fixture
Fitter
Post
Figure 3
Post
ReleasedDate:2017-09-29