Quoizel WKF8411EK Assembly Instruction Sheet

Please go to www.quoizel.com
Tools Required: Flathead screwdriver, Phillips screwdriver, pliers, wire cutters, wire strippers, electrical tape, safety glasses.
Light Source: (3) B10 Candelabra Base bulbs 60W Maximum or
(3) Candelabra Base T8 Vintage bulbs are recommended but not supplied.
Estimated Assembly Time:
Preparation: Identify and inspect all parts before beginning installation. Check package content list and diagrams below to ensure all parts are
present. If any parts are missing or damaged, do not attempt to assemble, install, or operate the fixture. Contact customer service for replacement
parts.
Fixture can only be mounted in the direction indicated on page 2.
Warnings and Cautions
Turn off electricity at circuit breaker or main fuse box before installation. Consult a licensed electrician if in doubt.
These instructions are provided for your safety. It is very important you read them completely before installing the fixture. We strongly
recommend that a licensed, professional electrician perform the installation.
Disconnect fixture from power source before replacing bulbs. Make sure bulbs are given sufficient time to cool before removal.
Package Contents
Crossbar Assembly
A
x 1
Alternate
B Mounting screw
x 2
-
STEP 1 Install Glass Panels
A. Unscrew screws from the top edge
of the Cage (E) to remove glass
holder.
B. Insert Glass Panels (D) into the slot
in the bottom edge of the Cage (E).
Attach the glass holder onto the top
edge of Glass Panels (D) and align
holes on it to mounting holes on the
Cage (E). Secure the glass holder
with removed screws. Tighten
gently until snug with screwdrivers.
Need assistance with parts or assembly? Call Quoizel customer service at 1-800-645-3184
2017 QuoizelInc.
Assembly Instruction Sheet #IS-WKF8411EK
for product cleaning tips. Go to the
20-30 minutes
Fixture Body
C
x 1
Cage
E
x 1
Slot
Thank you for purchasing a Quoizel product.
or visit us on-line at www.quoizel.com
For Style WKF8411EK
Care + Maintenance selection.
-
STEP 2 Install Cage
A. Remove lock screws from the bottom edge of the fixture hood.
B. Align the label "A" on the top edge of the Cage ( ) to the label "A" in
the bottom edge of the fixture hood.
panels to the fixture hood and secure with removed lock screws.
Hand tighten until snug with screwdrivers.
Glass
D Panel
x 4
Screw
Figure 2
Glass
Holder
-
STEP 3 Installing the Crossbar Assembly
D
A. Pass the supply wires through the Crossbar Assembly (A). Attach
the Crossbar Assembly (A) to the Outlet Box with the head of the
Green Ground Screw facing you. Secure the Crossbar Assembly (A)
with Outlet Box Screws (not included). Tighten until snug
Note: Use the Alternate Shorter Mounting Screw (B) if your
installation requires a shorter mounting screw.
Outlet
Box
E
Mounting Screw
or Alternate Short
Mounting Screw
1of2
E
Attach the Cage (E) with glass
Label "A"
C
Label "A"
Lock Screw
E
.
Outlet Box Screws
(not included)
A
Supply Wires
with Ground Wire
Figure 3
ReleasedDate:2017-09-29