Toshiba RAV-GV1101ATP-TR Service Manual page 94

No. Part name
1. Detachment
Inverter
3
assembly
1) Perform work of item 1 of
2) Take off screws of the upper part of the front
cabinet. (ST1T Ø4 ×10L, 2 pcs.)
• If removing the inverter cover under this
• If there is no space in the upper part of the
Be careful to check the inverter because high-
voltage circuit is incorporated in it.
Never disassemble the inverter for 1minute after
power has been turned off because an electric
shock may be caused.
3) Perform 1 of 2.
4) Take off screw between side cabinet
(right) and inverter box (wiring gate side)
(ST1T Ø4 × 10, 4 pcs.)
5) Take off screw between partition plate
and inverter box.
(ST1T Ø4 × 10, 1 pc.)
6) Take off screw (ST1T Ø4 × 10L) that fixed
between ASM-COV-WIRING and inverter
box then disengage ASM-COV-WIRING
from inverter box.
7) Remove connector of each lead wire type.
Procedure
condition, P .C. board can be checked.
upper cabinet, perform work of 2 .
CAUTION
WARNING
1 .
- 94 -
Remarks
Screws
Front cabinet
Inverter cover
Screws
Cord clamp
Screws
Screw