Table of Contents
Advertisement
8-2-3. Monitoring function of wired remote controller
<RBC-AMT
>
Content
Enter the service monitoring mode using the remote controller to check the sensor temperature or operation status of
the remote controller, indoor unit, and outdoor unit.
Push and hold the
1
mode.
The service monitor lights up. The CODE No.
2
Push the
button to change to CODE No. of the item to monitor. Refer to the next page
TEMP.
for CODE No.
3
Push the left part of the
monitor. Monitor the sensor temperature or operation status of the indoor unit and outdoor
unit in the refrigerant line.
4
Push the
button to return the display to normal.
<RBC-ASCU11- >
1
3
1
Push the [menu] button for over 10 seconds. "Monitoring function" is displayed on a screen.
2
Every pushing [
successively.
3
Push the [OFF timer] button to confirm the selected indoor unit.
4
Every pushing [
5
After you have finished checking, push the [ON/OFF] button, return to normal mode.
TEMP.
2
TIMER SET
TIME
FILTER
RESET
TEST
SET
4
, and
for 4 seconds or longer to enter the service monitoring
UNIT LOUVER
button (left side of the button) to change to the item to
Indoor unit
2, 4
5
or
] buttons, the indoor unit numbers in group control are displayed
or
] buttons, CODE No. of the item is changed successively.
ON / OFF
FAN
MODE
SAVE
VENT
CL
SWING/FIX
UNIT LOUVER
1
3
00 00 00 00 00
appears at first.
1,2
number
4
Data
- 44 -
"Monitoring function"
display
Advertisement
Table of Contents
Troubleshooting
