Recommended Procedure; Frame Preparation; Di2 Specific Parts - BMC TMR01 Owner's Manual

Recommended procedure

If you are building a timemachine frameset from scratch, the most convenient way is to follow the order and the procedure described
below. This is only the global procedure, all the seperate steps and recommendations are described one by one in the next pages of
this manual.
Please go through all the instructions before starting the assembly of the frameset.
1

Frame preparation

2 Mount the brake arms in frame
Rear brake cable routing
3
4 Shifting cable routing
5 Shifting cable routing
6 Derailleur, front and rear
Fork and headset
7
8 Stem
9 Handlebars
10 Front brake cable routing
11 Install the pipes on brake cables
Brake cable tension front and rear
12
13 Mount wheels and brake pads
14 Bolt on stem cover
15 Install top tube cable guide
16 Seat post installation
Crankset
17
18 Chain
19 Gears
20 Bar tape
Frame preparation

Di2 specific parts

When the frameset is built with Shimano Di2 groupset, replace the front derailleur cable stopper by the special cover
(highlighted in blue).
FD cable stopper for mechanical groupset
Part N° 210995
Cover for Di2 groupset
Part N° 210996
Building a timemachine
Refer to page 14, install rear wheel adjusters
Refer to page 15
Refer to page 19
Non Di2: Refer to page 27
Di2: Refer to page 25
Refer to manufacturers instructions
Refer to page 29
Refer to page 31
Di2: Refer to page 27
Refer to page 18
Refer to pages 19
Refer to pages 21 and 22
Refer to page 22
For TM01: Refer to page 36
Only for TM02
Refer to page 33
Mount the crank set once the rear brake is properly set
Refer to manufacturers instructions
Adjust the shifting, refer to manufacturers instructions
Wrap the bar tape as a final step