2-4. Door Liner Assembly
④
④
①
③
④
⑤
⑤
②
- 18 -
For Authorized Service Technicians
Dispenser Assembly
Using Dispenser Service Jig
① Close the Door.
② Disconnect Electrical wire connectors
from dispenser.
③ Insert the two side pieces into the inside
of the dispenser.
④ Insert the bottom piece.
⑤ After all three pieces have been inserted,
open the door and pull the dispenser
from the bottom up and pull out.
When pulling the dispenser out from the
door, lift the bottom of the dispenser
slightly from the inside, then remove the
bottom jig piece.
CAUTION: Watch pinch points to avoid
hand injuries.
Assembling New Dispenser
① Verify the status of the flanges on the
inner door.
② Place the support jig then insert the new
dispenser.
③ Make sure that all flanges fit properly into
the dispenser hooks. (8 point on picture ③,④)
※ Be careful injury on your hand.
※ If you don't understand this process, refer
to 80p.
※ Make sure the gasket is assmebled correctly.