HOMCOM 820-353V70 Manual Instruction page 3

Instructions to use
1. Power on or off with flame effect
2. Provides 800 watts of heat output operation.
3. Provides 1600 watts of heat output operation (can not operate without press switch 2)
4. Thermostat control knob (TEMPERATURE SETTING)
Installation of feet
Take out the whole machine, and put it on the flat table in order to avoid machine
scratching, then take the feet out of the plastic bag and connector (as shown in the
picture), the four foot could be turned and fixed.
Overheating safe device
If the heater stops working, turn the heater off and inspect the blockage of inlet or outlet.
Disconnect the plug and wait at least 10 minutes for the protection system to reset before
attempting to restart the heater. If the safe device still switches the heater off and makes
the heater fail to operate, take the heater to your nearest service center for examination or
repair.
Attention: before restarting the heater, the plug must be disconnected for at least 10
minutes
Table for information requirements for electric local space heaters.
3