Lan; Connecting The Lan Cable - Toshiba Satellite M40X-119 User Manual

Disconnecting
To disconnect the internal modem cable, follow the steps below.
1. Pinch the lever on the connector in the telephone jack and pull out the
connector.
2. Disconnect the cable from the computer in the same manner.

LAN

The computer is equipped with LAN circuits that support Ethernet LAN
(10 megabits per second, 10BASE-T) and Fast Ethernet LAN
(100 megabits per second, 100BASE-TX). This section describes how to
connect/disconnect to a LAN.
Do not install or remove an optional memory module while Wake-up on
LAN is enabled.
Wake-up on LAN does not work without the AC adapter. Leave it
connected, if you are using this feature.

Connecting the LAN cable

The computer must be configured properly before connecting to a LAN.
Logging onto a LAN using the computer's default settings could cause a
malfunction in LAN operation. Check with your LAN administrator
regarding set-up procedures.
If you are using Fast Ethernet LAN (100 megabits per second,
100BASE-TX), be sure to connect with a CAT5 cable. You cannot use a
CAT3 cable.
If you are using Ethernet LAN (10 megabits per second, 10BASE-T),
you can connect with either a CAT5 or a CAT3.
To connect the LAN cable, follow the steps below.
1. Turn off the power to the computer and to all external devices
connected to the computer.
2. Plug one end of the cable into the LAN jack. Press gently until you hear
the latch click into place.
3. Plug the other end of the cable into a LAN hub connector.
Check with your LAN administrator before connecting to a hub.
User's Manual
Connecting the LAN cable
Operating Basics
4-5