135 f fixed temperature heat detector ac powered, 120v 60 hz with battery backup (7 pages)
Summary of Contents for Edwards GasCheck G3 Magshield
Page 1
P601-01-140 Issue A Addendum Addendum to GasCheck G3 (D141-32-880) (To be shipped with NRD886000) Description Item Number GasCheck G3 Magshield NRD 886000...
Page 3
P601-01-140 Issue A Introduction Scope of this addendum This document provides specific technical information and instructions for the use of the GasCheck G3 Magshield leak detector. Please read this document in conjunction with instruction manual D141-32-880 issue A. WARNING Warnings are given where failure to observe the instruction could result in injury or death to people.
Page 4
Spare battery holder (with 4 batteries) Calibration certificate Operation Getting started Figure 1 - Screens displayed during GasCheck G3 Magshield startup Displays the gas with which the GasCheck G3 has been calibrated with. Displays the Magshield splash-screen followed by the serial number and firmware version.
Page 5
In the event of the fan current constantly exceeding 600 units, for example if the GasCheck G3 Magshield fan has reached the end of its working life, the unit will not display the leak rate and the GasCheck G3 Magshield should be returned to Edwards for servicing.
Page 7
This page has been intentionally left blank.
Page 8
This page has been intentionally left blank.
Page 9
Complete the Declaration (HS2) and send it to Edwards before you dispatch the equipment. It is important to note that this declaration is for Edwards internal use only, and has no relationship to local, national or international transportation safety or environmental requirements.
Read the Return of Edwards Equipment – Procedure (HS1) before you complete this Declaration • Contact Edwards to obtain a Return Authorisation Number and to obtain advice if you have any questions • Send this form to Edwards before you return your equipment as per the procedure in HS1...
Page 11
This page has been intentionally left blank.
Need help?
Do you have a question about the GasCheck G3 Magshield and is the answer not in the manual?
Questions and answers