Connecting The Dash Cam To Power Supply - Car and Driver CDC-E4000 User Manual

4. Find a good spot on the windshield to install the Dash Cam, and clean the area.
NOTE: The view should be unobstructed, and not blocking the drivers view of the road.
5. Remove the film from the adhesive side, and then stick the mount onto the wind-
shield, make sure it is firmly adhered.
6. Turn the knob of the mount to adjust the camera's angle. Make sure the Dash Cam
remains level with the vehicle and the road. Turn the Dash Cam on to check the camera
angle.
3M adhesive tape

2-3 Connecting the Dash Cam to power supply

1. Connect one end of the supplied USB - Type C cable to the CDC-E4000's Type
C port, and the other end to the supplied car power adapter. Plug the Car power
adapter into your car's DC power outlet.
2. Route the power cable around the ceiling/passenger seat so that it does not
interfere with driving. Included cable clips can be used to secure the cables out
of harms' way. Remove the film from the adhesive side to stick the cable clips on
the dashboard along the routing way, then place the cable into the clip and press
in to fix it.
Notes You may choose to tuck the cable with included tool between the paneling
of your windshield and/or A-pillar space if available.
Note
Make sure that the cable routing does not interfere with your car's airbags
or other safety features.
USB Car power
adapter (Supplied)
To your car's DC
power outlet
Knob
Screw
To CDC-E4000
Dash Cam's
Type-C port
7 EN
Press