Table of Contents
Advertisement
LED Functions
1. Red LED:
a. (Solid) Reversed Polarity, Bad Battery.
b. (Flashing) Wrong Battery
Voltage, Low Battery Voltage,
Short Circuit or Standby.
2. Green LED 6V:
a. (Solid) 12V battery charge complete
and charger is monitoring battery.
b. (Flashing) 12V battery charging.
3. Green LED 12V:
a. (Solid) 6V battery charge complete
and charger is monitoring battery.
b. (Flashing) 6V battery charging.
Maintenance Instructions
Procedures not specifically explained in this manual must be performed only by
a qualified technician.
TO PREVENT SERIOUS INJURY: Unplug the charger, disconnect
any battery, and allow charger to cool completely before performing
any inspection, maintenance, or cleaning procedures.
TO PREVENT SERIOUS INJURY FROM TOOL FAILURE:
Do not use damaged equipment. If abnormal noise or vibration occurs,
have the problem corrected before further use.
1. BEFORE EACH USE, inspect general
condition of charger. Check for:
•
loose hardware,
•
cracked or broken parts,
•
damaged electrical wiring or
cable insulation, and
•
any other condition that may
affect its safe operation.
2. If fuse needs replacing:
a. Unplug charger power cord from outlet.
Item 59520
For technical questions, please call 1-888-866-5797.
4. Tri-Colored LED:
a. (RED) Battery capacity
is lower than 40%.
b. (AMBER) Battery capacity
is 40% to 70%.
c. (GREEN) Battery capacity
is greater than 70%.
Green LED (6V)
Tri-Color LED
b. Disconnect Ring Terminal
Connectors from battery.
c. Uncap Fuse Housing.
d. Remove spent fuse
e. Replace with a new 7.5A
Blade-type fuse.
f. Recap Fuse Housing.
3. AFTER USE, wipe external surfaces
of tool with clean cloth.
Green LED (12V)
Red LED
Page 7
Advertisement
Table of Contents
