Viking 59520 Owner's Manual & Safety Instructions page 6

On-board battery maintainer
Table of Contents

Advertisement

Connecting
Read the ENTIRE IMPORTANT SAFETY INFORMATION section
at the beginning of this document including all text under subheadings therein
before set up or use of this product.
A SPARK NEAR BATTERY MAY CAUSE BATTERY EXPLOSION.
TO REDUCE RISK OF A SPARK NEAR BATTERY follow these instructions
exactly.
TO PREVENT SERIOUS INJURY:
Wear ANSI-approved splash-resistant safety goggles and heavy-duty rubber
work gloves whenever connecting, disconnecting, or working near battery.
Battery acid can cause permanent blindness.
TO PREVENT SERIOUS INJURY: DO NOT PLUG IN
CHARGER UNTIL DIRECTED TO DO SO.
WARNING! TO PREVENT SHORT CIRCUIT
AND FIRE: Do not leave Ring Terminal
Connectors installed indefinitely.
WARNING! TO PREVENT SERIOUS
INJURY: Do not connect Ring Terminal
Connector to carburetor, fuel lines, or
sheet-metal body parts. Do not leave Ring
Terminal Connectors attached indefinitely.
Note: This Charger is intended only to
keep a fully charged battery from losing
its charge. It will not work to charge a
battery that is discharged or damaged.
1. Connect and disconnect DC output Ring
Terminals Connectors only after unplugging
charger power cord. Never allow Ring
Terminal Connectors to touch each other.
2. Position cables to reduce risk of damage
by hood, door, or moving engine parts.
Page 6
For technical questions, please call 1-888-866-5797.
3. Stay clear of fan blades, belts,
pulleys, and other parts that can
cause injury to persons.
4. Check polarity of battery terminals.
POSITIVE (POS, P, +) battery post
usually has larger diameter than
NEGATIVE (NEG, N, –) post.
5. Unplug charger power cord from outlet.
6. Bolt POSITIVE (RED) Ring Terminal
Connector to POSITIVE (POS, P, +)
post of battery.
7. Bolt NEGATIVE (BLACK) Ring Terminal
Connector to NEGATIVE (NEG, N, –)
post of battery.CAUTION! Do not
turn on equipment that battery is
connected to while charging.
8. Plug in power cord to (GFCI) outlet.
9. When disconnecting charger, unplug
power cord from outlet, then remove
Ring Terminal Connectors from battery.
Item 59520

Advertisement

Table of Contents
loading

Table of Contents