Advertisement
-4- L
The same as LOAD" (add FILENAME",
DEVICES)
««- S
The same as SAVE" (add FILENAME",
DEVICES)
<4- M
Display menu
«4- R
Disable Disk Drive RATTLE ON ERROR
CHECK (To re-enable rattle, turn drive off
and on)
•4- D
Disable FAST LOADER but retain commands
+- E
Enable FAST LOADER
■<- H
Hard copy print out of the screen.
(screen dump)
ADDITIONAL INFORMATION
•
To disable COMMANDS, but not affect FAST LOADER type
SYS 57043
•
To enable COMMANDS ONLY type SYS 57054
•
To enable COMMANDS and FAST LOADER type SYS 57051
•
To enable FAST LOADER ONLY type SYS 57003 (with
BASIC+4K type SYS 57013 to enable FAST LOADER ONLY)
•
The directory list command "$" will use the device # for
the last drive accessed. You may directly select a device by
typing Poke 186.DV, where DV = Device number (8-11)
•
The " |", "@", "/", and " = " commands can reference
device # 8 only.
•
To perform a LOAD or SAVE to another device # you must
use the "-^ L" or "^- S" commands or normal BASIC
syntax.
•
Users of SYSRES (TM by Solidus International) can do fast
program file loads with MACH 5 but must use conventional
BASIC syntax (i.e. LOAD "FILE", DR).
•
There are very few programs that will not load with MACH 5
engaged. If a program does fail to load, try typing "•*- D"
to disable the FAST LOADER rather than removing the CAR
TRIDGE. The time required to load a program depends on
many factors including booting technique, error checking, etc.
Speeds up to 500% of normal are possible with long, single
file program loads. With copy protected programs it is usual-
Advertisement
