Page 9
dealing with drawers removing and replacing drawers 1. Remove the screw holding each slide rail and drawer bracket with a screwdriver 2. Lift the drawer front up and out of the slide rail buckle 3. Lift the drawer up and out to remove To replace the drawer, reverse steps 1-3 adjusting the upper and lower drawer faces If the two drawer faces are not even, follow these steps:...
anti-tip bracket for use in freestanding applications When drawers, racks and shelves are extended while loaded, there is a danger of tipping the unit. In these cases an Anti-Tip Bracket must be installed on the rear right or left side. ANTI-TIP BRACKET The Anti-Tip Bracket kit comes with a bolt and washers to mount to the rear of the refrigerator and three different sets of fasteners to mount it to any of the following: Dry Wall Construction, Wooden...
Page 13
let’s face it overlay panel dimensions 23 9/16” (594mm) 14 13/16” (376mm) Two panels are required Maximum Panel Thickness: 3/4” Maximum Panel Weight: 10 lbs each...
Page 14
let’s face it 1. Remove the four screws on both sides of the drawer and to remove it (see page 9) Then remove the (6) M5 attachment screws to detach the drawer face. for the overlay panel. REMOVING THE DRAWER GASKET panel location recess the handle attachment screw heads.
Page 23
- what are those sounds? Today’s advanced refrigeration systems incorporate the latest technology like high efficiency compressors and refrigerant evaporators which continually adjust their operation to maximize performance while saving energy.