Retrieve Messages From Memory - Multitone RPR 950 Series User Manual

Machine Translated by Google
then the display of any alphanumeric message and/or call
time/number data. After 4 seconds, the voice channel
automatically opens and the voice message is played.
The voice channel then closes automatically at the end of
a preset time, or when receiving a signal to end the reception
of a voice message, depending on your system.
If during the 4 second alert period, you press the OCR
button, this ends the call and if you press this button again,
this ends the voice message.
If you press the OCR button again during the voice message
timeout period, the voice channel will reopen.
All voice calls are automatically sent to voice storage memory
for later retrieval (see section 8).
After the alert period, if you press the OCR button, this cancels
the call (eliminates its status again) but if you press the
button again, the voice channel opens at
new.
If the calls remain uncancelled, your pager goes into extended
alert mode, if this option has been selected.

7. RETRIEVE MESSAGES FROM MEMORY

Unless cancelled, messages are automatically stored in your
pager's memory. Up to 5 free message formats of 120
characters in length and up to 4 pre-programmed messages
of 14 characters in length can be stored. Once the memory
is full, each new message received erases the oldest.
Message retrieval is initiated from standby by pressing the
OCR button twice. If the pager is in
9261 – 9629 Issue 2
RPR 950 Series
10