Advertisement
Audio Meters Tab
• •
•
Tone Generators Tab
• •
•
Settings Tab
The Settings tab shows the current settings for the 10-position DIP switch located on the bottom of the BBG-
EMDE-AES unit. The Status LED mirrors the status shown on the LED on the edge of the BBG-EMDE-AES
unit.
Powering Down BBG-EMDE-AES with Custom GUI Settings
BBG-EMDE-AES requires the AC adapter to make certain adequate power is supplied to the
unit. To make certain BBG-EMDE-AES powers-down as intended and properly saves any
custom settings, power-down as follows:
1
After settings have been made, wait until the STATUS LED on the unit stops flashing
amber and is solid green. (Flashing amber state means BBG-EMDE-AES is currently
saving custom settings; green means state has been saved in memory and unit can be
powered down.)
2. Disconnect the USB connection.
3. Disconnect the AC adapter from the AC line or the unit itself. BBG-EMDE-AES are now
saved and will re-appear upon next power-up. Unless the settings need to be changed,
only the AC adapter connection is necessary for powering BBG-DE-AA in field use.
Relative signal levels can be checked for
all embedded and AES audio inputs
using the Audio Meters tab.
Individual tone generators Tone 1 thru Tone 8 can be set for
desired frequencies and routed to embedded or AES output
channels using the Output Routing controls. Tone 1 thru
Tone 8 all provide a -20 dBFS level.
Note: Multiple tone generators, even if set to the same
frequency, may not exhibit phase coherence. If identical
tones with frequency and phase coherence are required,
use a single tone generator (e.g., "TG1") across multiple
channels instead of multiple generators set to the same
frequency.
3
Cobalt Digital Inc.
2506 Galen Drive
Champaign, IL 61821
Voice 217.344.1243 • Fax 217.344.1245
www.cobaltdigital.com
BBG-EMDE-AES_CONFIG-OM (V1.4)
© 2016 Cobalt Digital Inc. All Rights Reserved
Advertisement
