Wellness NE100 User And Service Manual page 3

Thank you for using our heat pump for the heating of your spa, it will heat your spa water
and keep a constant temperature when the ambient air temperature is at -25~43℃
ATTENTION: This manual includes all the necessary information about the use and
the installation of your heat pump.
The installer must read the manual and attentively follow the instructions of implementation
and maintenance.
The installer is responsible for the installation of the product and should follow all the
instructions of the manufacturer and the regulations in application. Incorrect installation
against the manual implies the exclusion of the entire guarantee.
The manufacturer declines any responsibility for the damage caused by people, objects and
errors due to the installation against the manual. Any use that isn't in accordance with the
origin of its manufacturing will be regarded as dangerous.
WARNING：
Do not use means to accelerate the defrosting process, other than those recommended
by the manufacturer.
The appliance shall be stored in a room without continuously operating ignition sources
(for example: open flames, an operating gas appliance or an operating electric heater.)
Do not pierce or burn.
Be aware that refrigerants may not contain an odour.
This heat pump shall be installed, operated and stored in a open room larger than 3 m³.
Note the manufacturer may provide other suitable examples or may provide additional
information about the refrigerant odour.
WARNING: If you power off heat pump, please empty the water in heat pump always
during winter time or when the ambient temperature drops below 0℃, or else the titanium
heat exchanger will be damaged because of being frozen, in such case, your warranty
will be lost.
WARNING: Please always cut the power supply if you want to open the cabinet to reach
inside the heat pump, because there is high voltage electricity inside.
WARNING: Please keep the display controller in a dry area, or close the insulation cover
to protect the display controller from being damaged by humidity.
12 September 2023/ DH [Hier eingeben] Seite 2 von 26