Table of Contents
Advertisement
Jump Starter and Power Source
OWNERS MANUAL
PLEASE SAVE THIS OWNERS MANUAL AND READ BEFORE EACH USE.
This manual will explain how to use the jump starter safely and effectively. Please
read and follow these instructions and precautions carefully.
CONTAINS SEALED, NON-SPILLABLE LEAD-ACID BATTERY. MUST BE DISPOSED OF PROPERLY.
WARNING: Possible explosion hazard. Contact with battery acid may cause severe burns and blindness.
Keep out of reach of children.
1.
IMPORTANT SAFETY INSTRUCTIONS
WARNING – When using this product, basic precautions should always be followed, including the following:
1.1 Read all the instructions before using the product. Failure to do so could result in serious injury or death.
1.2 To reduce the risk of injury, close supervision is necessary when the product is used near children.
1.3 Do not put fingers or hands into the product.
1.4 Do not expose the power pack to rain or snow.
1.5 Use of an attachment not recommended or sold by the power pack manufacturer may result in a risk of fire,
electric shock, or injury to persons.
1.6 To reduce risk of damage to the electric plug and cord, pull the plug rather than the cord when
disconnecting the power pack.
1.7 Do not use a battery pack or appliance that is damaged or modified. Damaged or modified batteries may
exhibit unpredictable behavior resulting in fire, explosion or risk of injury.
1.8 Do not operate the power pack with a damaged cord or plug, or a damaged output cable.
1.9 Do not disassemble the power pack, take it to a qualified service person when service or repair is required.
Incorrect reassembly may result in a risk of fire or electric shock.
1.10 To reduce the risk of electric shock, unplug the power pack from the outlet before attempting any instructed
servicing.
1.11 WARNING – RISK OF EXPLOSIVE GASES.
a. WORKING IN VICINITY OF A LEAD ACID BATTERY IS DANGEROUS. BATTERIES GENERATE
EXPLOSIVE GASES DURING NORMAL BATTERY OPERATION. FOR THIS REASON, IT IS OF
THE UTMOST IMPORTANCE THAT YOU FOLLOW THE INSTRUCTIONS EACH TIME YOU USE
THE POWER PACK.
b. To reduce risk of battery explosion, follow these instructions and those published by battery manufacturer
and manufacturer of any equipment you intend to use in vicinity of the battery. Review cautionary
markings on these products and on engine.
2.
PERSONAL PRECAUTIONS
2.1 Consider having someone close enough by to come to your aid when you work near a lead-acid battery.
2.2 Have plenty of fresh water and soap nearby in case battery acid contacts skin, clothing, or eyes.
2.3 Wear complete eye protection and clothing protection. Avoid touching eyes while working near battery.
2.4 If battery acid contacts skin or clothing, wash immediately with soap and water. If acid enters eye,
immediately flood eye with running cold water for at least 10 minutes and get medical attention immediately.
2.5 NEVER smoke or allow a spark or flame in vicinity of battery or engine.
2.6 Be extra cautious to reduce risk of dropping a metal tool onto battery. It might spark or short-circuit battery
or other electrical part that may cause explosion.
For the manual with Spanish, visit www.batterychargers.com or call 1-800-621-5485.
Para obtener el manual en español, visite www.batterychargers.com o llame al 1-800-621-5485.
FOR MODELS
BE01255
FR01337
SJ1289
SPR1631
0099001923-04
Advertisement
Table of Contents
Related Manuals for Schumacher Electric BE01255
Summary of Contents for Schumacher Electric BE01255
- Page 1 Jump Starter and Power Source FOR MODELS BE01255 OWNERS MANUAL FR01337 SJ1289 PLEASE SAVE THIS OWNERS MANUAL AND READ BEFORE EACH USE. SPR1631 This manual will explain how to use the jump starter safely and effectively. Please read and follow these instructions and precautions carefully.
- Page 2 2.7 Remove personal metal items such as rings, bracelets, necklaces, and watches when working with a lead- acid battery. A lead-acid battery can produce a short-circuit current high enough to weld a ring or the like to metal, causing a severe burn. 2.8 When charging the internal battery, work in a well ventilated area and do not restrict ventilation in any way.
- Page 3 CHARGING THE INTERNAL BATTERY OF THE PORTABLE POWER IMPORTANT! CHARGE IMMEDIATELY AFTER PURCHASE, AFTER EACH USE AND EVERY 30 DAYS, TO KEEP THE PORTABLE POWER’S INTERNAL BATTERY FULLY CHARGED AND PROLONG BATTERY LIFE. 4.1 CHECKING THE LEVEL OF THE INTERNAL BATTERY To check the internal battery’s charge status, press the Battery % button.
- Page 4 4. For a positive-ground vehicle, connect the portable power’s NEGATIVE (BLACK) clamp to the NEGATIVE (NEG, N, -) battery post. Next, connect the POSITIVE (RED) clamp to the vehicle chassis or engine block away from the battery. IMPORTANT: If you have connected the clamps backwards, an audio alarm will sound. DO NOT turn the On/Off switch to the ON position.
- Page 5 12V DC ESTIMATED RUN-TIMES APPLIANCE TYPE EST WATTAGE ESTIMATED RUN TIME Cell phone 4 watts 54 hrs Fluorescent light 4 watts 54 hrs Radios, fans 9 watts 24 hrs Depth finder 9 watts 24 hrs Camcorder 15 watts 14.4 hrs Electrical tool 24 watts 9 hrs...
- Page 6 5.8 USING THE CONVERTER It is important to know the continuous wattage of the device you plan to use with the converter. The portable power must be used with devices drawing 200 watts or less. If the wattage is not marked on the device, use only devices that draw less than 1.7 amps of AC current.
- Page 7 MAINTENANCE AND CARE 6.1 Clean the clips and the case each time you are finished using it. 6.2 Recharge the unit once a month when not in use. 6.3 Store clips on their support posts, to ensure they do not come into contact with any metallic surface. 6.4 Never completely discharge the internal battery.
- Page 8 THIS LIMITED WARRANTY TO THE ORIGINAL RETAIL PURCHASER OF THIS PRODUCT. THIS LIMITED WARRANTY IS NOT TRANSFERABLE OR ASSIGNABLE. Schumacher Electric Corporation (the “Manufacturer”) warrants this portable power for one (1) year and the internal battery for ninety (90) days from the date of purchase at retail against defective material or workmanship that may occur under normal use and care.
Need help?
Do you have a question about the BE01255 and is the answer not in the manual?
Questions and answers
when and how do i need to use an inverter
Use the Schumacher Electric BE01255 inverter only with devices that draw 200 watts or less. If wattage is not labeled, use devices that draw less than 1.7 amps of AC current. Avoid devices with high starting power like TVs or fans, as they may exceed the inverter’s surge capacity and cause automatic shutdown. Always test a device before full use to check compatibility. Ensure the device supports a modified sine wave converter. Keep the inverter ventilated, dry, and away from flammable materials. Do not use it with high wattage devices, as this may cause damage.
This answer is automatically generated
I can’t figure out how to use the compressor. I have it plugged into the wall and I just I can’t. I can’t get it to start.
To operate the Schumacher Electric BE01255 compressor:
1. Remove the air compressor hose from the storage compartment in the back of the unit.
2. Connect the adapter to the valve stem by threading it on. Use an additional adapter if needed.
3. Press the Compressor button.
4. Use the “+” or “–” buttons to select the desired PSI, then press the SET button.
5. The compressor will stop automatically when the desired pressure is reached.
6. Unthread the connector from the valve stem.
7. Press the Compressor button again to turn off the display and LEDs.
8. Do not run the compressor for more than 10 minutes at a time. Let it cool for 10 minutes before reusing.
9. Return the hose to the storage compartment.
10. Allow the unit to cool and recharge it before storing.
Note: The compressor has built-in thermal protection and will shut off if it overheats. Wait a few minutes before restarting if this happens.
This answer is automatically generated
Can I use the charger to charge my car battery?