Philips FTP2.4A Service Manual page 9

face down on the (ESD protective) foam bars, a stable situation
is created to perform measurements and alignments.
By placing a mirror under the TV, you can monitor the screen.
4.2.2 Aluminium Stands
Figure 4-3 Aluminium stands (MkI)
The new (MkII) aluminium stands (order code 3122 785 90690)
can also be used to do measurements, alignments, and
duration tests. The stands can be (dis)mounted quick and easy
by means of sliding them in/out the "mushrooms".
Important: For (older) FTV sets without these "mushrooms", it
is obligatory to use the provided screws, otherwise it is possible
to damage the monitor inside!.
4.3 Assy/PWB Removal
4.3.1 Metal Back Plate
Caution: Disconnect the mains power cord before you remove
the metal back plate.
1
1
Figure 4-4 Metal back plate
1. Place the TV set upside down on a table top, using the
foam bars (see part "Foam Bars").
Caution: do not put pressure on the display, but let the
monitor lean on the speakers or the Front cover.
2. Remove all T10 parker screws [1] from the top, centre, and
left and right sides of the back plate.
3. Remove all T10 tapping screws [2] from the bottom of the
back plate.
4. Remove the four "mushrooms" [3] from the back plate.
5. Lift the back plate from the TV. Make sure that wires and
flat foils are not damaged during the back plate removal.
Mechanical Instructions
E_06532_019.eps
170504
1
3
1
1
1
2
F_15460_074.eps
140405
FTP2.4A AA
4.3.2 Rear Cover
2
1
Figure 4-5 Rear cover
1. Disconnect all connectors [1] at both Ambient Light
Inverters that go to the Ambient Lights in the rear cover.
2. Remove all T10 tapping screws [2] around the edges of the
rear cover.
3. Lift the rear cover from the TV.
4. EN 9
2
2
2
F_15460_073.eps
140405