Distributing The Sealant - Hyundai ix35 2015 Owner's Manual

8. With the engine start/stop button
position on or ignition switch posi-
tion on, switch on the compressor
and let it run for approximately 5~7
minutes to fill the sealant up to
proper pressure. (refer to the Tyre
and Wheels, chapter 8). The infla-
tion pressure of the tyre after filling
is unimportant and
checked/corrected later.
Be careful not to overinflate the
tyre and stay away from the tyre
when filling it.
CAUTION
- Tyre pressure
Do not attempt to drive your
vehicle if the tyre pressure is
below 200kpa(29 PSI).
could result in an accident due
to sudden tyre failure.
9. Switch off the compressor.
10. Detach the hoses from the
sealant bottle connector and
from the tyre valve.
Return the TyreMobilityKit to its stor-
age location in the vehicle.
will be WARNING
Do not leave your vehicle run-
ning in a poorly ventilated area
for extended periods of time.
Carbon monoxide poisoning
and suffocation can occur.
This

Distributing the sealant

11. Immediately drive approximately
Do not exceed a speed of 80
- Carbon
km/h (50 mph). If possible, do
monoxide
not fall below a speed of 20
km/h (12 mph).
Whilst driving, if you experience
any unusual vibration, ride dis-
turbance or noise, reduce your
speed and drive with caution
until you can safely pull off of
the side of the road.
Call for road side service or tow-
ing. When you use the Tyre
Mobility Kit, the tyre pressure
sensors and wheel may be dam-
aged by sealant, remove the
sealant stained with tyre pres-
sure sensors and wheel and
inspect in authorized dealer.
What to do in an emergency
4~6 miles (7~10 km or, about
10min) to evenly distribute the
sealant in the tyre.
CAUTION
6 31