Distributing The Sealant - Hyundai IX35 2014 Owner's Manual

EL(FL) Eng 6.QXP 7/11/2013 10:53 AM
8. With the engine start/stop button
position on or ignition switch posi-
tion on, switch on the compressor
and let it run for approximately 5~7
minutes to fill the sealant up to
proper pressure. (refer to the Tire
and Wheels, chapter 8). The infla-
tion pressure of the tire after filling
is unimportant and
checked/corrected later.
Be careful not to overinflate the tire
and stay away from the tire when
filling it.
CAUTION
- Tire pressure
Do not attempt to drive your
vehicle if the tire pressure is
below 29 PSI(200kpa).
could result in an accident due
to sudden tire failure.
Page 29
9. Switch off the compressor.
10. Detach the hoses from the
sealant bottle connector and
from the tire valve.
Return the Tire Mobility Kit to its stor-
age location in the vehicle.
will be
WARNING
- Carbon
monoxide
Do not leave your vehicle run-
ning in a poorly ventilated area
for extended periods of time.
Carbon monoxide poisoning
and suffocation can occur.
This
What to do in an emergency

Distributing the sealant

11. Immediately drive approximately
7~10 km (4~6 miles or, about
10min) to evenly distribute the
sealant in the tire.
CAUTION
Do not exceed a speed of 80
km/h (50 mph). If possible, do
not fall below a speed of 20
km/h (12 mph).
While driving, if you experience
any unusual vibration, ride dis-
turbance or noise, reduce your
speed and drive with caution
until you can safely pull off of
the side of the road.
Call for road side service or tow-
ing. When you use the Tire
Mobility Kit, the tire pressure
sensors and wheel may be dam-
aged by sealant, remove the
sealant stained with tire pres-
sure sensors and wheel and
inspect in authorized dealer.
6 29