Hyundai ix35 2015 Owner's Manual page 329

Features of your vehicle
VOICE RECOGNITION
Using Voice Recognition
Starting Voice Recognition
Shortly press the key on the steering
wheel remote controller Say a command
4 244
If voice recognition is in [Normal Mode],
then the system will say "Please say a
command. Beep~"
• If voice recognition is in [Expert Mode],
then the system will only say a "Beep~"
• To change the Normal Mode/Expert
SETUP
Mode setting, go to
[Prompt Feedback] / [Voice Recognition
System].
✽ ✽ NOTICE
For proper recognition, say the com-
mand after the voice instruction and
beep tone.
Contact List Best Practices
1) Do not store single-name entries (e.g.,
"Bob", "Mom", "Kim", etc.). Instead,
always use full names (including first
and last names) for all contacts (e.g.,
use "Jacob Stevenson" instead of
"Dad").
2) Do not use abbreviations (i.e., use
"Lieutenant" instead of
"Sergeant" instead of "Sgt.").
3) Do not use acronyms (i.e., use
"County Finance Department" instead
of "CFD").
4) Do not use special characters (e.g.,
"@", "hyphen -", "asterisk *", amper-
sand &").
5) If a name is not recognized from the
contact list, change it to a more
descriptive name (e.g., use "Grandpa
Joseph" instead of "Pa Joe").
Skipping Prompt Messages
Whilst prompt message is being stated
[System]
Shortly press the
ing wheel remote controller
The prompt message is immediately
ended and the beep tone will sound.
After the "beep", say the voice command.
Re-starting Voice Recognition
Whilst system waits for a command
Shortly press the
ing wheel remote controller
The command wait state is immediately
ended and the beep ton will sound. After
the "beep", say the voice command.
"Lt." or
key on the steer-
key on the steer-