Table of Contents
Advertisement
3-4
Installing the CPU
Read the following guidelines before you begin to install the CPU:
• Make sure that the motherboard supports the CPU.
• Always turn off the computer and unplug the power cord from the power outlet before installing
the CPU to prevent hardware damage.
• Unplug all cables from the power outlets.
• Disconnect all telecommunication cables from their ports.
• Place the system unit on a flat and stable surface.
• Open the system according to the instructions.
WARNING!
Failure to properly turn off the server before you start installing components may cause
serious damage. Do not attempt the procedures described in the following sections unless
you are a qualified service technician.
Follow these instructions to install the CPU:
1.
Align the processor to the carrier so that the gold triangle on the processor aligns with the triangle
on the carrier, and then install the processor into the carrier.
NOTE: Apply thermal compound evenly on the top of the CPU.
2.
Remove the CPU socket cover.
NOTE: Save and replace the CPU socket cover if the processor is removed from its socket.
Carrier Types used for Package Types
Package Type
Carrier Code
NOTE!
•
The carrier code is marked on each carrier and matches a code laser marked on to the IHS(Integrated
Heat Spreader) to ensure the right parts are used together.
•
When installing the coolant pipe module to CPU,use T30-Lobe driver to tighten 4 captive nuts in
sequence as 1-4.
•
The screw tightening torque: 8 ± 0.5 kgf-cm.
Pin1
Xeon® SP XCC
E1A
1
System Hardware Installation
- 31 -
Xeon® SP MCC
E1B
2
Xeon® SP+HBM
E1C
Advertisement
Table of Contents
