Table of Contents
Advertisement
Refer to "Technical data"
chapter.
To activate the function for a cooking
zone: touch
.
To deactivate the function: change the
heat setting.
5.6 OptiHeat Control (3 step
Residual heat indicator)
WARNING!
/
/
indicator is on, there is a risk of
burns from residual heat.
The induction cooking zones produce the
heat necessary for the cooking process
directly in the bottom of the cookware. The
glass ceramic is heated by the heat of the
cookware.
The indicators
/
cooking zone is hot. They show the level of
the residual heat for the cooking zones you
are currently using.
The indicator may also appear:
• for the neighbouring cooking zones even
if you are not using them,
• when hot cookware is placed on cold
cooking zone,
• when the hob is deactivated but the
cooking zone is still hot.
The indicator disappears when the cooking
zone has cooled down.
5.7 Timer
Count Down Timer
Use this function to specify how long a
cooking zone should operate during a single
cooking session.
Set the heat setting for the selected cooking
zone and then set the function.
You cannot activate the function
while the Hob²Hood function is
running.
As long as the
/
appear when a
1. Press
. 00 appears on the timer
display.
2. Press
or
minutes).
3. Press
to start the timer or wait 3
seconds. The timer begins to count
down.
To change the time: select the cooking
zone with
and press
To deactivate the function: select the
cooking zone with
remaining time counts back to 00.
The timer finishes counting down, a signal
sounds and 00 blinks. The cooking zone
deactivates. Press any symbol to stop the
signal and blinking.
Minute Minder
You can use this function when the hob is
activated but the cooking zones do not
operate. The heat setting shows 00.
You cannot activate the function
while the Hob²Hood function is
running.
1. Press
.
2. Press
or
The timer finishes counting down, a signal
sounds and 00 blinks. Press any symbol to
stop the signal and blinking.
To deactivate the function: press
. The remaining time counts back to 00.
5.8 Power management
If multiple zones are active and the
consumed power exceeds the limitation of
the power supply, this function divides the
available power between all cooking zones
(connected to the same phase). The hob
controls heat settings to protect the fuses of
the house installation.
• Cooking zones are grouped according to
the location and number of the phases in
the hob. Each phase has a maximum
electricity loading. If the hob reaches the
limit of maximum available power within
to set the time (00-99
or
.
and press
. The
to set the time.
and
ENGLISH
11
Advertisement
Table of Contents
