Table of Contents
Advertisement
Before applying power
For the U.S.A. and Canada
Important!
Units shipped to the U.S.A. and Canada are designed for operation
on 120 volts AC only.
CAUTION:
To PREVENT ELECTRIC SHOCK DO NOT USE
THE AC PLUG WITH AN EXTENSION CORD, RECEPTACLE OR
OTHER OUTLET UNLESS THE BLADES CAN BE FULLY INSERTED
TO PREVENT BLADE EXPOSURE.
For the United Kingdom
Important!
Units shipped to the U.K. are designed for operation on 240 volts
AC only.
Tha mains plug must ba removed from the walt socket prior to any
internal examination,
Tha wires in this mains Jead are colourad in accordance with the
following code:
The wires in this mains lead must be connected to the terminals
in the plug as follows:
Wire colour
Piug terminal marking
N or Black
L or Red
Brown to
Blue to
Neutral
Notes:
+. Ifa 13-amp plug is used, this must be fitted with a 5-amp fuse.
2. Ifa 3-pin plug with earthing contact is used, no wire must be
connected to the E terminal.
Safety precautions
ZN Caution:
Read this page carefully
to ensure safe operation.
For Europe
Important!
Units shipped to Europe are designad for operation on 230 V AC
only.
For other countries
Important!
AC adaptor shipped to countries other than the above are
equipped with an AC valtage selector switch on the
bottom cover. Refer to the following paragraph for the
proper setting of this switch.
AC voltage selection
AC adaptor operates on
110 ~ 120 voits or 220 ~ 240
volts AC. Before connecting the power cord to your AC
outlet, make sure that the setting position of this switch
matches your line voltage. If not. it must be set to your
voltage in accordance with the following diraction.
Note:
Our warranty does not cover damage caused by exces-
sive lina voltage due to improper setting of the AC voltage
selector switch.
110
220
110
220
130 WT
ve
are
ins a
a
110 V-120 V
220 V~-240 V
The AC adaptor is providad with a voltage selector switch which
has been preset for 220-240 V,
if using it with 110- 120'V power, set the switch to the
110-720
V positian.
AC voltage selector switch
Fig. 1
WARNING:
TO PREVENT FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THIS APPLIANCE TO RAIN
OR MOISTURE.
The marking of products using lasors
{Except for some areas).
:
CLASS 1
.
m
LASER PRODUCT
This label is attached to the bottom panel and says that the
component usas laser beams that have been classified as Class 1,
It means that the unit is utilizing laser beams that are of a weaker
class. There is no danger of hazardous radiation outside the unit.
4
En)
WARNING NOTICE:
IN MOST CASES IT IS AN INFRINGEMENT OF COPY-
RIGHT TO MAKE COPIES OF TAPES OR DISCS WITH-
OUT THE PERMISSION OF THE COPYRIGHT OWNERS.
ANYONE WISHING TO COPY COMMERCIALLY AVAIL-
ABLE TAPES OR DISCS SHOULD CONTACT THE ME-
CHANICAL COPYRIGHT PROTECTION SOCIETY LIM-
ITED OR THE PERFORMING RIGHTS SOCIETY LIMITED.
Advertisement
Table of Contents
