Maintenance; Before Applying Power - Kenwood DPC-X301 Instruction Manual

Maintenance
Simple care
Care of lens
When the lens in the pick-up gets dirty, malfunctions including the
impossibility of playback may occur. The lens should be cleaned
using a commercially available camera lens blower, etc Do not touch
the lens to prevent damaging the mechanism Also do not use a
lens cleaner or disc cleaner product.
Care of main unit
When the unit gets dirty, clean with a soft, dry cloth. If the unit is
stained seriously, a moistened cloth can be used. Do not use benzine
or thinner for these will damage the unit.
Cleaning the plug
Wipe the headphone plug with a soft cloth to keep it clean.
A dirty plug may cause noise or malfunction.
Caution on disc used
Usable discs
This unit is capable of playing discs marked with 'iMT . Other discs cannot be played.
8 cm single CDs can be played as they are; do not use a commercially-available single CD
adapter.
Handling
Hold compact discs so that you do not touch the playing surface
Do not attach paper or tape to either the playing side or the label side of compact discs.
Never play a cracked or warped disc.
During playback, the disc rotates at
high
speed in the player Therefore, to avoid danger, never
use a cracked or deformed disc or a disc repaired with tape or adhesive agent.
Cleaning
If fingerprints or foreign matter become attached to
the disc, lightly wipe the disc with a soft cotton cloth
(or similar) from the center of the disc outwards in a
radial manner.
Storage
When a disc is not to be played for a long period of time, remove it from the CD player and store
it in its case.
Precaution against condensation
Immediately after a room is heated or in a room with high humidity (or vapor), the unit may
malfunction due to the condensation of dew or mist on the pick-up lens In such a case, leave
the unit for about an hour before trying to use it again
Before applying power
' Caution: Read this page carefully to ensure safe operation.
AC adaptors are designed for operation as follows.
L/.S.A and Canada....AC 120 V only
For the U.S.A.
FCC WARNING
This equipment may generate or use radio frequency energy. Changes or modifica equipment may
cause harmful interference unless the modifications are expressly approved in the instruction manual.
The user could lose the authority to operate this equipment if an unauthorized change or modification is
made.
NOTE:
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment may cause harmful
interference to radio communications, if if is not installed and used in accordance with the
instructions. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on. the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
- - Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
— Consult the dealer or an experienced radio/TV technician for help.
For CANADA
Canadian 1C Compliance Notice
NOTICE This Class B digital apparatus meets all requirements of the Canadian inlerference-
Caussig Equipment Regulations.