Toshiba CX36F67 Owner's Manual page 10

Using the Remote with VCR or Cable TV Converter
• To control a TOSHIBA VCR, first set the TV/CABLENCR switch to VCR. The buttons shown below will then control the
VCR. The rest of the buttons operate the TV as usual.
If you have another brand of VCR, you can probably program the Remote Control to control il.
Details are on page 11.
• To control a cable TV converter, this Remote Control must be programmecl to recognize the brand of your converter.
See page 11.
Set the TV/CABLE/VCR switch to CABLE whenever you want to control the cable TV converter.
Aim at the VCR or cable TV converter
TV/CABLENCR switch
"TV" : To control this TV
"CABLE" : To control cable
TV converter
"VCR"4 Tn control VCR
Channel number buttons
Press the numbers desired
for direct access.
REWind button
Press to rewind tapes.
In playback mode, press to view
picture moving rapidly in reverse. "_--,
STOP button
Press to stop the tape.
RECord button
Press to start recording.
PAUSE/STILL button
Press to freeze tile picture
during playback or recording.
Press again to release.
SLOW button
Press to view a slow-motion
picture in playback mode.
n
m
n
®®
®®
®®
@
REW
SWAP
NV
_V_ |
A!
VOL I
vl
SOURCE
POWER button
Press to turn the VCF1
(or conve *ter) on.
Press again to turn.off.
CHANNEl. • / • buttons
Press • to select the next
higher channel.
Press •to select the next lower
channel.
RTN_utton
See _age 20.
PLAY button
Press to begin tape playback.
"_-_ FF button
Press to rapidly advance the tape.
In playba(:k mode, press to view the
picture m :)ving rapidly forward.
TV/VCR [:utton
Press to select the TV mode to
view one program while recording
another program.
-q
Shaded but4ons can be used to control I
the cable TV converter
!
10