Milwaukee M18 FUEL 2732-20 Operator's Manual

Milwaukee M18 FUEL 2732-20 Operator's Manual

7-1/4" circular saw
Hide thumbs Also See for M18 FUEL 2732-20:

Advertisement

Quick Links

OPERATOR'S MANUAL
Cat. No.
2732-20
M18
FUEL ™ 7-1/4" CIRCULAR SAW
TM
WARNING
To reduce the risk of injury, user must read and understand operator's manual.

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the M18 FUEL 2732-20 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Milwaukee M18 FUEL 2732-20

  • Page 1 OPERATOR'S MANUAL Cat. No. 2732-20 FUEL ™ 7-1/4" CIRCULAR SAW WARNING To reduce the risk of injury, user must read and understand operator's manual.
  • Page 2 GENERAL POWER TOOL at all times. This enables better control of the power SAFETY WARNINGS Read all safety warnings, instruc- WARNING • Dress properly. Do not wear loose clothing or jewelry. Keep your hair and clothing away from tions provided with this power tool. Failure to moving parts.
  • Page 3 Kickback could cause the saw sive temperature. cut for any reason, release the trigger and hold • Follow all charging instructions and do not charge the saw motionless in the material until the Charging im- to remove the saw from the work or pull the saw may occur.
  • Page 4 • If the guard immediately springs back into place, it is SYMBOLOGY • If the guard does not immediate spring back Volts into place, clean the upper and lower guards to Direct Current • If the guard still does not immediately spring back into place, contact a MILWAUKEE service facility...
  • Page 5 Installing and Removing Blades Adjusting Bevel Angle spindle lock button, use the wrench provided with clean the spindle, upper guard and lower guard to NOTE: Spindle Bolt the handle to the desired angle as indicated by Adjusting the Blade to Shoe with the teeth pointing in the same direction as place saw on the blade side and retract lower Adjusting Depth...
  • Page 6 • Support large panels to minimise the risk of Large panels tend needs servicing by an authorized MILWAUKEE ser- placed under the panel on both sides, near the line and you must always wait for the blade to stop com-...
  • Page 7 Continuous overloading may cause permanent dam- Cutting Masonry and Metal Ripping Wood MILWAUKEE circular saws are not intended for con- does not recommend using bonded abrasive wheels The width of the cut is the distance from the inside of Dust, chips, and grit can cause WARNING guard to hang up at any time.
  • Page 8 MILWAUKEE If the tool does not start or operate at full power with a fully charged battery pack, clean the contacts on erly, return the tool, charger and battery pack, to a...

Table of Contents